Recent content by Cobrargc

I've got a midrise scissor lift. It works great, but I'm concerned about it's safety. I also have a 4 post lift and it has a safety latch on all four corners. If one fails, there are three others. The scissor lift only has one latch. If it fails, I'm in trouble. I'll do brake work and such...

I don't see these valves listed in the parts breakdown. It appears to be a Sanborn B5900 pump. http://www.mastertoolrepair.com/stationary-two-stage-electric-air-compressor-parts-sv8048049-v6548049-v8048049-bv6548049-cv6548049-p-759498.html

I've got a Coleman Powermate upright 80 gallon, 6.5 HP air compressor. The last month or so it begun to make an odd sound. It's not a knocking or hammering sound to indicate serious internal issues, but more of a "gurgling" sound. The sound comes and goes as it's running. It sounds like it...

Thanks guys!

I've got a midrise scissor lift. It works great but is designed more for older vehicles that sit a little higher. It doesn't lend itself well to modern vehicle that sit lower to the ground. I need to find a way to make this work. I've though about making some accompanying wooden ramps that...

Mine rolls right out of the garage with the dollies. It's way to much work for one person. I did it once by myself and that was the last time. Initially the power head wouldn't allow the lift to clear the door. I created a temporary hanger for the power head just around the same upright...

Hello to everyone. I've got a Dannmar 4 post lift approximately 5 years old. A few years ago I had an issue with the electric motor "shuttering or laboring" to raise with or without weight. Eventually the start capacitor exploded. I replaced the start capacitor and all was well for a...