Recent content by colin.mitchell.129

Yeah it's rock solid now. The hole through the wall is very tight with the pipe. I think if the frost heaves it up it will split the pipe at that 90 up top. Sent from my SM-N910V using Tapatalk

Northwest Ohio is the location. I'll update my profile, thanks. Sent from my SM-N910V using Tapatalk

While I'm at it, should he ground it to the grounding point in the picture, or is there no need for it to be grounded. Sent from my SM-N910V using Tapatalk

So my buddy just finished up with a gas line project. I told him he needs a swing joint but I don't know how he would do it. He has 3/4" black pipe, the underground sealed inside pvc pipe. The exposed part is in the pic. Where it has a 90 at the top and goes through the wall, the inside is just...

No worries. It should be as much as this cat iii cost. Lol Sent from my SM-N910V using Tapatalk

Thanks for the clarification. The 4" pipe inside the thimble (6" pipe) is that airspace your referring to? So the wood paneling, insulation, and osb can be touching the outside of the thimble, or I need space around that? Sent from my SM-N910V using Tapatalk

I'm going horizontal through a wall. And isn't the thimble the "pipe in a pipe?" It's essentially a 4" pipe going through a 6" pipe. I'm just trying to figure out what clearances are needed from the thimble to everything else. Sent from my SM-N910V using Tapatalk

I just figured as many of these types of heater install topics on this forum, surely someone has used a cat iii thimble through a standard wall. Sent from my SM-N910V using Tapatalk

That's what I would think but there's not even 8" from the pipe edge to the edge of the thimble flashing. Sent from my SM-N910V using Tapatalk

Can anyone help me? I've read hours and hours of older topics on here and can't find the answer. Sent from my SM-N910V using Tapatalk

In the middle of installing my beacon morris 45k btu garage heater. I'm horizontally venting with 4" cat iii pipe. Just making sure I get the wall thimble correct. It says on the sticker that it needs 8" clearance to combustibles. Essentially it's a 4" pipe going through a 6" pipe(thimble) so...

Yes it has 24v. The common wire is what was confusing me. So a simple dial thermostat would just use the red and white, but I need the common in addition to actually power the thermostat. Thanks for your help. Sent from my SM-N910V using Tapatalk

I'm currently installing a beacon morris 45k btu heater in my garage. I also bought a Honeywell digital programmable thermostat to go with it. The beacon morris guy told me I only need 2 wire(red and white only) thermostat wire, but I think I need more than that for this to work. Menards sells...