Copymutt's latest activity
-
CI make a few parts for obsolete machines. I love an excuse to use my South Bend 13. I make these replacement arbors for old Millers...
-
CCopymutt replied to the thread Need advise on how I should weld this drive shaft..Will need to custom make a set for conversion from NP 203 to NP205 transfer cases. What are the conventional points to take length...
-
CCopymutt reacted to vpd66's post in the thread Need advise on how I should weld this drive shaft. with
Like.
All good suggestions. I do these all the time and have a thick walled piece of angle iron to clamp it too. I TIG weld all mine so I know... -
CCopymutt replied to the thread Does Radiant Floor heat make sense.Times 2 on the mix of in floor and hanging Modine for the shop. Neither has been expensive to operate. Zone 7. Each has its strengths...
-
CYou say parking only but.........we all know how that will go once you have the building. So, the above 'fixed' drawing is more...
-
CFixed it for you:
-
CCopymutt reacted to slomaro3.4's post in the thread What did you do "IN" your garage today? with Like.
And an access panel in the floor is better than dropping a grand with a shop to drop the tank and replace. I'll have to make it look...
-
CCopymutt replied to the thread What did you do "IN" your garage today?.Welded up a hitch step for the 57. Incorporated back up & 3 rd brake lights into it. Started out making the welds look purty, then...
-
-
CCopymutt replied to the thread What is this?.Concur on the brick hauler, seen similar newer, same design.
-
CCopymutt replied to the thread What is this?.Closest AI can find is leveling device for ladder scaffolding. Close, but no cigar.
-
CCopymutt replied to the thread What is this?.Not sure of the action, but entertaining a fence stretcher.
-
CCopymutt replied to the thread Wood Stove: How many cords?.Racking is alternating the direction of the split wood by 90* leaves a huge amount of airflow. Downside is you wont be able to fit as...
-
CIn theory, there is a wall back there somewhere. I wish I had some room for decorations. Lee
-
CCopymutt replied to the thread Wood Stove: How many cords?.This was my near zero cost build as a wood shed. Using pallets blocks wind driven rain/snow, but leaves plenty of airflow for drying. If...
-
-
CCopymutt replied to the thread where to locate stand alone garage.Take any shade trees into consideration as well as that scorching Texas Sun. You can orient OH bay doors on any side w/ just a bit of...
