Recent content by coyotehunter

IT LIVES!! After replacing the busted line I switched the pump in and return hoses and it’s working now!! Who hoo!! Just need to change the locations on the loader up and down to get it to operate it what would be a normal action. It makes sense that the pump in would be same side as the...

I believe it’s a 100. K241as Kohler engine in it. Haven’t found and serial number on it to see what it really is yet.

Thanks. Red is return as we speak and blue is from the pump. I will switch them tomorrow after work. Pump doesn’t have any issues until you try to move something. I shall let you know what happens after I move the piping.

I have a new to me cub cadet with what I believe to be a p f engineering loader mounted to it. The issue I have is the loader does not want to function properly. Neither bucket or loader arms function correctly and it almost stalls the engine trying. The piping on the cylinders are correct. The...

There was a magazine years ago called “home power” That I believe you can still read online that you might want to check out. It may give you some more option ideas.

See if this is what you are looking for. https://www.kyleswitchplates.com/how-to-install-centered-switch-or-outlet-on-2-gang-box/#large-junction

Wiring looks correct. Remove R sub c as you do not have ac and make sure you don’t have the thermostat set to cooling.

I was looking at doing this as well. I wanted a mobile welding/fab cart to work on projects outside. My plan is to use an rv plug ( 4 prong) in the garage between the garage doors and run it to a small breaker box attached to my cart. Then I have enough power for welder and grinder/cutoff...

This is what I have and used for years. https://yellowjacket.com/product/deluxe-45-flaring-tool/

https://www.tarantin.com/blog/propane-101/proper-line-sizing

Any WiFi thermostat would work. Your heater should only be a 2 wire for the thermostat. R and W is all you need. Just configure the installer setup for 2 wire heating only and you should be good.

Dewalt makes a battery powered propane forced air propane heater that would probably do what you are looking for. If you have other 20v dewalt tools it would be a good option

I put the same on my tool cart so that I could wheel it from my garage to my vehicle and it semi works. The width of the cart is too narrow and the casters don’t like to turn when a change of direction is in order. If I were to do it again I would make a frame to hold out the wheels farther and...

Here is the before and after of my mini split cleaning.

I installed 3 Chigo mini splits about 14 years ago and I have cleaned mine once. I used the rectorseal mini split cleaning system. After I got past the cheap ”frame” to hold the plastic funnel bag it actually worked pretty well. I used 2 regular pump sprayers. One with hot water and the other...