Recent content by craig1701

I purchased a Dannmar 7000 4 post lift through Northern Hydraulics last week and will be receiving the lift this Friday. I was looking at there caster kit #101002 which is $400.00 and I would like to make my own kit I already have the 4ea 6" casters and was wondering if someone had this caster...

It is getting cold here now and I started up my new furnace and noticed that it only puts out Luke warm heat with my hand right in front of the furnace and if I move my hand around the front of the furnace I have areas of cool air and no heat. All 4 burners are lit and stay lit but it does not...

Thanks Menards has 4/0-4/0-4/0-2/0 mhf for $3.19 a ft which I can afford What would I use for the correct breaker in the 200 amp panel in the house and what would I use to connect that size of wire to the breaker?

I have some changes to the distance of the run. I need to move the pole barn further away from the main box to meet the city codes for setbacks and now the run will be 250 ft Can I still get by with the 2-2-2-4 at that length? I will be using a 240v air compressor that requires 22 amps and a...

I am going to be putting up a 38x64x12'6 pole barn this spring and couple of things that I am thinking about are the overhang and the condensation blanket on the roof. What are your thoughts on both of these ?

Hello everyone, This is my first post I am going to install a 100 amp service in a new 30x40 pole barn workshop this fall hopefully and need some electrical advice I have a 200 amp service in the house right now and will be putting in an underground service to the pole barn, It is 115' from...