Recent content by Crazy old geezer

Need help with a very early model Southbend 10L Lathe. Are the tailstock Quills the same on the newer models? I know there are two diff. keyway sizes 3/16" and 1/4" I need a 3/16" That will work

I haven't tried to run it yet but the unloader tubes were not on it , I'll put them on. in the morning and see what happens

I have acquired a Quincy air compressor that has no ID tags . and It won't pump enough air to shut it off. The compressor was supposedly sent to Quincy 5-6 yrs ago for this problem and was supposedly fixed. I need to identify it so I can get parts if needed Photos attached. Any help will be...

As stated yesterday here is a photo of the Pulley The hub fits tight in the bearing and loose on the pulley quill drive.

Thank you for the advice, but were it that easy it would be out by now. Due to the design of the pulley there is no way to get to the inner race. I may try to photograph the pulley later today but it will be difficult. The drive splines for the Quill extend inside the bearing even with the...

Hello New to the site. 70 plus years in mechanics, 5 in machinery maintenance and 60+ in automotive and heavy equipment, so the problem I am having should be no real problem, But :dunno: Last summer I purchased a B/C mod 1600 drill press to use for wood working. I paid $75.00 for it, which I...