cretedog's latest activity

I was going to post the same thing. I should have done the mini-splits right away. A forklift came after the shop was built and I use...

Insulate the walls and finish them. I had a pole barn built with the eventual intentions of insulating it and finishing the walls...

Happy 4th of July everyone!!!

Once in a lifetime vise. Bonney Rapid Transit #160 5-1/4" jaw width 10" opening Parker style jaws Fast acting gear rack and pawl coarse...

Put them on stands on the ground and run the duct where it needs to go. Some people get the wild idea to mount them on a stand 15 feet...

I had a large Plomb collector reach out to me looking to divest a large portion of his collection. After working with the collector...

Original power hammers were sand-cast. The company also made about a dozen of salesman items- fully functional miniature hammer. The...

Lynchburg Plow and Foundry Company?

Our stuff is pretty grippy. There's a pattern on them for extra grip and they're not glossy/slippery like normal heat shrink. Before...

Here is a pick up from last weekend's GS adventures. This was a Tool & Die maker's joy to own. He was quite proud of it, bought it...

I bet something skyhook like could be made from one of these HF cranes, and they are fairly cheap. Pickup bed crane Smaller pickup bed...

I keep my rotary table, angle plate, and vise on a rolling cart. Just roll it up to the mill, lower the table to the right height, and...

I'm going through a massive old vise, and replacing parts that are beat up. One vise jaw was broken, so I made a new pair. I made them a...

I got bored last January and did as you suggested above. Looked at jib cranes, davit cranes, engine hoists etc. Saw the pickup cranes...

You guys realize that receiver size is only a small factor in the decision of what to buy for an air compressor? The pump is first and...