Recent content by CROmech

I use automotive antifreeze.

I have a large shed so a lot of stuff will be stored in there. All I will have in the garage it a toolbox and a workbench.

I did some measuring. Im pretty sure i can fit another vehicle beside the lift.

I will have a 13.5’ ceiling.

Maybe I can stretch it to 25’ wide.

Hey all I am finally in the position to build a detached garage. I’ve wanted one since I was 16, and i’m 40 now. Nows the time. Anyhow, i’d like a 2 post hoist installed and space for another vehicle beside it. I have attached a quick drawing of what I can build according to bylaws. Where...

You can fit a 2 post in a 24’ wide garage if installed 2’ from the side. You can park a car beside it as well.

Good quality plywood (1” at least) and 14g SS sheet over top

Put the 7” wire wheel on. Was hitting the sides so I took the covers off. This grinder is from the 70’s and runs as smooth as butter! Eventually I will add the multitool belt sander attachment.

Can somebody tell me what bearings I need for the 397.19440 and 21155 grinders? Thanks

Just aquired these 2 grinders: $125 cdn for the 3/4 hp $65 cdn for the 1/2 hp

First one is 5.4 A and second one is 5.1 amp

Hey guys Which of these 2 grinders is better and why? Both are 3/4 hp

Hello I am somewhat of a Record Vice collector. I am about to purchase a nos in box authentic Record, but, it doesn’t say “made in England” on the actual vice. The box however states “Designed and manufactured in Sheffield, England”. Well what do you guys think about that?

I think Snapon at one point had the master series made overseas.