Recent content by cs80

I too have that problem, 2x top that has warped over the years. Though, mine is attached with bolts so i could remove the planks and redimension them, but if you come up with some way that's less work id be interested.

I made some aluminum plates for the drill press vice to hold tall square stock. the only problem is when i bolt the plates to the vice the plates go out of square slightly, so i need to figure out whats going on there and grind down some sides of the plates to fix it. i think it may be they a...

The plans look great, will be a dream shop. As for the different capacity panel decisions, for me it was about wire gauge. i was at the home store looking at the wire i would have needed for 200 amp service and wondering if i was looking at rebar by mistake. even 125 amp is crazy thick. i...

Thanks, I am from Hastings, a small town but not quite as small as Worthington; now i'm in St Paul. What part of Iowa are you? My mother's family was from Waterloo; still go there for reunions.

Hello, I've been in my garage for years but went for a long time using it to store a bunch of household junk and abandoned projects with just a bench, some automotive tools, and a chop saw; just in the past 6 months I have had all the junk hauled away and began turning it into a real shop where...