Recent content by CunningStunt

Thanks man! I bought this from a company that makes warehouse buildings, i guess they always run more than they need for a contract and have lots left over. I bought enough 24ga panels to wrap around a 24x48 barn two full times! They were eager to get rid of it and I got it for $1000. Super...

I cut a pine down behind barn and cut them in sections of about 6-8" w/ a 45 angle on one end, attached it to a 2x6 pine and torched. Came out pretty neat!

Updates on barn build! Here are pictures of my gable end siding. Been busy but finally got back to the barn.

What an awesome building! Where is it located? I would consider a mezzanine but thats about all the input i can give.

Theyre great, and I only paid 5000 for pole barn and install. They seem pretty tough and I have yet to see a bird using them to perch. They held up during hurricane michael and I saw 85mph gust 50 sustained

So, half will be a shop and the other half will house 3 stalls. I came up with what i think is a really good floor plan and am considering a closed in loft on a 12x24 foot section at one end, and then a general shop/storage area. Here is a pic of my floor plan. The dashed line is the 2nd...

I am closing both gable ends and will wall the 12' section on the front side on both ends. Here is a pic of my work from yesterday on the gable end girts.

Showing progress of my 24x48 12'eave pole barn project. I put the barn up 2 years ago but just started closing it in 3 weeks ago First weekend after I put Girts on Got a great deal on this 24ga siding. 16ft 18" wide. Had to cut every piece down to 12ft Half the wall up: Whole...

https://photos.app.goo.gl/GNhpBNB5Hvi6y6Lt5

I will draw up what i am thinking with stall design and send google photo link

Hello, I got one of my walls closed up over the weekend - 48ft. I want to continue to close the gable end as well. i am 12' OC 6x6 posts and I put in 4x4's in between each 6x6's and ran them 9 feet up and then put the girts on. 12' eaves metal trusses 16' peak. There is a lot of space to...

So I am going to put girt up this weekend on my barn. its 24x48 X12'eave Its metal truss so there is a lot of valuable space to be had with a loft. My question is about trying to clear span 24' with 12' joist from the end wall to the 24' beam. I would like to avoid a center free post if...

Great info. I do not have requirements for pole barns outside city limits, and other than another super rare storm, tornadoes are my only other concern in regards to wind. my posts are 48" below and set in quickcrete but no rebar. I will however later be laying down concrete which will also...

24'x48' 12' eave 6x6 posts 12' OC I am being told conflicting methods of running girts to attach the tin to. Half of the barn will be horse stalls and the other half my workshop and a fully finished mother-in-law type setup for a small stove tv and maybe wall hung bed. Method 1 - 2x6x12 36''...