Recent content by cvcman

Legacy 850 sometimes both sensors are lit and it works fine, other times one is blinking red and the other is off It will go up but not down unless u hold the button on the wall unit Wires look ok but not 100 percent Can I bypass these sensors ? Is this a bad sensor ? Thank you

So if I was to try and pack under the slab from outside , would stone dust be best ? Then top off around the outside to cover the skirt board ?

How ?

Yea I wish , the area is crawling with them It’s in a field When I prepared the area by brush hogging they were running all over

😂 no that’s a home made poison trap for moles There is bait that hangs down inside and they go in the tube and eat it

Yea not a single crack in that 28 x 40 slab ( knock on wood )

Ahh well as I said. I dig away a little stone with my finger to get under the rim board , and then stick my finger under it I can feel the bottom rough side of the slab … but there a space between the bottom of the slab and the ground

Not sure It wasn’t exposed

It’s weird because they put down heavy plastic before pouring and I don’t feel it under there

Another

More

Try again

Here’s some pics, seem like even in the spots u don’t see the board if you dig the gravel away with your finger there’s a void there where I can feel the bottom of the slab not touching the ground

Just saw a video of someone shooting closed cell foam to fill the gap ? I’ll try to get pics today

It’s a steel sided pole barn Ground sloped away …siding sealed at the sill with steel .. kinda like upside down J channel I’m not sure what the pc is called