Recent content by d-m

If your interested in the full tear down and repair you can see it here on my FB page you will have to scroll the page but it is all there. https://www.facebook.com/groups/1560695147483264/

Hi I have been trolling here for a few days thought I would join up and make an introduction. Some may have seen my post about my junk store find Wilton vise (50.00 bucks had it in my car) also my camel back drill press post. I live in Oregon and have a regular job and a small machine shop at...

Thanks for the links what I am needing is a measurement on what appears to be the pin that locks the fixed jaw. It would just save me from trying to get the taper right if you don't have any info I will ask on the thread and don't worry the Wilton will be mounted and used as it was meant to be...

Thanks for the welcome this was the only thread I found in a google search for that vise. I have trolled around this forum for more info could not find BIG Vises would you mind adding a link to direct me to the one you mentioned? It will be a month or so before I get serious about putting this...

Hi new to the board thought you may like to see a few photos of my prentice bro drill press. When I got it home it was a mess cleaned and painted also the pic of how I repaired the well abused table.

Hi new to the board thought I would pop in and say hi.Found this at a local junk store a few days ago needs a quick going over and a few parts made up.