Recent content by DanEng

The circular saw I got is Parkside, it is a brand sold by Lidl supermarkets. For DIY, they are good value for money, at least till this episode. Regarding the attachment of the saw body to the base/frame, it does not seem to have any screws or adjustments.

Hi all, I inserting washers between the cam and part attaching the base, and aligned the blade as much as I could. Now the cut is much better. The kerf is a lot narrower than was before, around 3mm which is very near the 2.8mm stated on the blade. Also, the tendency of trying to pull to the...

Yes it is the adjustment to set the depth of cut, right? I was thinking of inserting a washer between the cam and part attaching the base.

Parkside PHKSA 20-Li B3 https://www.amazon.de/dp/B0BZWYV4XT/ And yes in fact the guide is not square to the arbor as can be seen in my posted photos unfortunately.

I do not see any adjustment for this kind of misalignment. I will check if I can insert a shim somewhere or try to bend the metal connections from the base to the main housing.

Hello to all, Following the very good advice and help everyone offered here, I might have found the reason for the wide cut (I am understanding that it is called kerf) and also why the saw is always tending to one side. I have observed and checked with a combination square that the bottom plate...

I have made a mistake in writing down the thickness, it is around 27mm not 40mm, but you are right the tool I bought is not a heavy duty item, it feels.

I will try a single pass. And I became aware that I have made a mistake in writing the plywood thickness, it is not 40mm but around 27mm, Sorry about this. This is the plywood I am trying to cut: https://pmhobby.com.mt/wp-content/uploads/2021/06/F360_P27SH20_21869-scaled-1-1200x847.jpg

Hi all, Thanks for the suggestions, I will check the items you suggested. To be clearer, I am using the circular saw with a straight edge guide with clamp to try to get a straight cut, but not like the Makita which was suggested by Jack Stand. Mine clamps the work and you have to press the...

Hello, I am new to wood work and I have a question regarding the width of cut using a circular saw. I have bought a circular saw taking a 150mm blade. I replaced the blade from the standard 24 teeth to a KWB branded 48 teeth one to get finer work finish. I have a number of shutter plywood (the...

Got the set from Bosch. I will see how it goes.

Nice drill sets. These look much better than the generic carbide tip drills I have.

Thanks

Is this the set you pointed out? https://www.amazon.de/dp/B094183BMV/

Hello, Does anyone know of a good manufacturer or the original manufacturer of the 4-edge cross drill bits, as shown on the link below? Are these any good? https://www.amazon.com/dp/B0C817MS3S/?tag=atomicindus08-20 Thanks