Recent content by darkfader

That second set of cables goes out to the shed. I can move those down to another breaker and just use all 4 spaces.

Ok I haven’t been home all week and I actually forgot that my outdoor main disconnect has spaces for 4 single pole breakers. Is there any reason why I can’t wire directly into this with my feeder? I attached a photo. Would my ground and neutral just go into the same bar and then unbind the...

Thanks! Nope, you got it. That’s exactly how I’ll have to do it. I think I’ve got a good plan now. Thank you guys very much.

Thanks for all the suggestions gents. I guess I wanted to use the copper because I was under the impression that it would be easier to work with than the aluminum. Since my run is rather short, the added expense wasn’t really an issue. I need less than 30 total feet. I also thought I could use...

Ok thanks. I guess I’ll just figure out a way to do the conduit panel to panel. Garage side will be easy, house side will be a challenge.

Ok I appreciate the help. One more question, if I were to use the individual conductor THHN/THWN linked above, would I still need the conduit panel to panel or could the conduit terminate at the wall? Thanks again for the help

I have been trying to study everything I need to know in order to feed power to my new shop but with all the info, my head is spinning. I’m hoping some experts can lend a hand. I will attempt to be as specific as possible here. I have 200 amp service with a Square D Homeline panel in my home...

Yes sir! I’m a little less than two hours from summit

Been lurking for a while to study up on buildings and figured I’d register since construction on my building has begun. Tons of info here and I’m trying to digest it all. I contracted out the construction of the floor and shell, and I’ll be finishing the interior myself. The crew just started...