Recent content by davaldez21

Sounds good thanks

I did my 2nd coat today,made a big difference from the first coat. As far as the flakes do I sweep up first or use a blower to pick up loose flakes or do I roll the clear on top with loose flakes?

thank you for the responses, Im doing the 2nd coat later today, it will be about 21-22 hrs after 1st coat, manufacturer advised on 12-48 hr window for 2nd coat. I hope to upload some pics once the 2nd coat is done.

Hello, I put down my first coat of Rustoleum Professional Epoxy (Solvent based). Today it is drying, i did notice some uneven gloss areas. I am pretty sure its because I had a little bit of epoxy after doing first coat, and didnt want to throw that epoxy away so I spread it over some thinned...

I am using Rustoleum Professional Solvent Based. I plan on applying 1 coat late today. Would want to do second coat tomorrow. Directions state a recoat time of 72-96 hrs at 50 F and 16-72 hrs at 70 F. (Weird temperatures since pot life is listed at 70F, 90F and over 90F). Temperature here...

Yes 400 sq ft solvent based epoxy in my garage with a clear urethane, aliphatic , single component moisture cured

Coat Coat

Thanks that's good advice

Any tips to keep consistent thickness on solvent based epoxy and urethane. I bought all the recommended equipment including NAP roller, and have been looking at techniques.

So for a solvent based epoxy I should be ok to remove right after finishing the each coat (2 hrs or so)?

I read on a couple of posts of not putting blue painters tape when using epoxy bc it will get embedded easily. Duct tape was recommended. What would be best for covering edges, and removal time?

Local SW do not carry armor seal hs in stock in light gray. They offered to tint to desired color, haze gray Any downsides with this? I need 2 kits so I'd be mixing the two 1 gallon tints before doing first and second coats

Would you mind elaborating on this I can't seem to play that clip

So I'm getting ready to do my epoxy this weekend. I finally found some local urethane I could use, aliphatic moisture cured single component urethane by sherwin Williams. I'm having to drive 2 hrs to get it. Anyways I had originally bought rustoleum professional solvent epoxy based due to good...

Does rusteolum solvent based professional hold up against the sherwin Williams epoxy?