Recent content by davbell22602

Paying someone else to do it is not option at this time.

How does it hook up to air compressor?

It takes 7 seconds to drop to 90 from 120.

How well does it work?

Can you use the fine abrasive in the speedblaster?

Cost too much have someone blast the stuff for me. Here's the specs on the Brute. Maximum Operating Pressure 125 PSI Horse Power 2.5 (running) CFM @ 40 PSI 5.1 CFM @ 90 PSI 4.2 Found this one http://www.harborfreight.com/20-lb-pressurized-abrasive-blaster-68994.html

I have 10 gallon Brute. I have some suspension parts that need blasted on 67 F100.

Thats fine. Time isnt a issue. Where are they sold at?

Do they make low pressure sandblaster with wond for small air compressors? I care less how it takes to get the job done longs it gets done. I know they make low pressure paint guns.

No luck with google.

Here's pic of the kerosene heater.

Does anybody know how to ignite this Sears kerosene heater to get it to come on? 155.70011 If anybody has manual for this share that would be great also.

I'll probably go with these to see how well they work.

Thanks

So which set by norseman should I get?