Recent content by dawgn86

Keep my Dremel in mine

Wonder how these would work for the small Dremel tools and bits?

Jarhead would you happen to have a link for those Astro's or an item number?

Hi Neighbor is selling two of these brand new / never used Craftsman tool boxes...17" deep 26.5" wide 34" tall....$200 each..is this a good deal?

Hey guys If you were to go out and buy an ultrasonic cleaner, what would you get? I'm looking for one to just clean small engine carburetors and parts. Would like to have one that heats, has a drain and with electronic controls. Thanks

Check out Northern Tool stores... I'm no expert, but consider a unit with a Honda GX Engine with a Comet or CAT pump and horizontal shaft.

Tekton just came out with some snap ring plier options

carry this with me as well as a small 1/4" socket set..always something to fix at the parents, inlaws or kids houses.

spot on post! I think you just had to be there in these past Sears stores.....remember going with my Dad to the Sears in our hometown in the 70's and when they opened up a new mall where I live now in 1980, it had a brand new Sears. Many days of walking those tool and hardware aisles looking...

My Northern Tool Honda GX 160 engine starts usually on the first pull. If you have the water on, release the pressure by squeezing the trigger wand first.

you are correct.... i also owned the Pittsburg one from HF, but it was hard to get the socket off. Took it back and replacement did the same.

anyone use the HF Titanium Easy Flux 125? I have never welded, but would like to learn and have something smaller for repairs on mower decks, etc

Tekton makes a good one.

Nice job!

I bought a cheap 3/4" socket set off of Facebook marketplace for $25. Internals were gummed up so I took it apart to clean and lube. It came with a metal case, extension about 17 sockets. Probably wont ever use it.