Recent content by dcrahn

  1. D

    beer fridge???

    Beer doesn't stay in my frig long enough to worry about it freezing.:beer:
  2. D

    New Member, this is so cool!

    It's and oven I bought off my next door neighbor when he was remodeling his kitchen. I use it primarly for powder coating small parts, but I also use it to make a pot of coffee for those cold mornings.
  3. D

    New Member, this is so cool!

    Yes it is Miracle Truss. It's 36 x 48 with 12ft walls. I did everything myself except the concrete work and the Icynene spay foam insulation.
  4. D

    New Member, this is so cool!

    It's about 20 miles northwest of Savannah. We race at Savannah River Dragway, it's a new track that opened this year after the old Savannah Dragway closed.
  5. D

    New Member, this is so cool!

    Here you go Scott. It's a Ford big block bored and stroked to 598 cu in. Ford SVO A460 Block **** Billet Crankshaft 4.5 Stroke **** H Beam Rods JE Forged Pistons 4.6 Bore-14:1 Compression Trick Flow A460 Heads(ported by Charlie Evans of Evans Racing Engines) Jomar Stud Girdles Trick Flow A460...
  6. D

    New Member, this is so cool!

    Thanks! With two stages of nitrous it should run 4.70's to 4.80's in the 1/8 mile. On the engine dyno it made 995 hp and 820 lbft torque without the nitrous.
  7. D

    New Member, this is so cool!

    I just joined up when I found about this place and I thought this is too cool, a forum for garages. Here are a couple of pics of my shop I finished about 3 years ago and the first project to be built in it. The shop is a little dirty right now as I am franticly trying to get the car finished...
Top Bottom