Recent content by deaner70

Got my new floor going finally. It sure is a defferent heat than I was used to having thats for sure. Outdoor burner providing the fire, runs in and through a plate heatercircualting. The other side of the plate feeds the floor. No problems so far

I was looking @ Ebay for a 009 Taco pump for my floor and I found these pumps listed as an alternative. Are these good/bad, or any comments on them. I like the 75-100 dollar savings, but I won't buy something cheaper if not as good of quality. I will be using on a closed system, 4 loops...

Thanks for the info. Trying to get it up and running. The local heating guy suggested making it a closed system with distilled water and anti-freeze, then adding a plate heater and a pump. I am heating with a Central BOiler. Says its more efficiant than using a mixing valve. Says to come...

Looking at the different manifolds out there, I came across one that is (or appears) to be stainless steel. I also seen them at Menards. IT is a ki that has both supply & return pipes, flow meters, valves, etc and it is all mounted on a bracket that will screw to a wall. My question is, are...

Hi everyone..Long time lurker, first time poster...I am in the process of getting the new shop floor heat hooked up and I have several questions. 1st. I am feeding this with a Central Boiler that also feeds the house. The pipe is in to the shop and I have 4 loops in the floor. The shop is...