Recent content by deranged

Well that complicates my first printer purchase. I liked the idea of Prusa much more than Bambu or Qidi, etc, but was worried about their lagging feature set. I wish the kit was available for purchase.

https://www.garagejournal.com/forum/threads/small-rod-bender.494427/ Something like this?

I've had excellent results using a combo of the above mentioned Gore filter and a pre-filter from Outerwears. Keeps the bulky stuff out of the filter. https://outerwears.com/products.asp?cat=12929

https://guardair.com/ Pricey, but you get what you pay for.

Disclaimer: hobbyist at best, hack most days. I have the Esab Sentinel Helmet that's in the OP, I bought it with my Rebel EM215ic due to a discount, and wanting to cry once. I've used other ones over the years, (mostly at work) including a couple of cheap ones that would eventually fail at...

Highly doubt it. 1/4" thick, doubled'up side plates with welded construction will be significantly more rigid than those bolt together, 16 gauge stamped steel precursor to ikea workbenches. Even more so if the doubled up sides were even partially boxed.

Nice, I'm about to start my own build on one. I'm just going with a single axle for simplicities sake, I wan't to go with walking beam, just didn't want to have the extra cost.

What's the roll of paper for?

So the big takeaway that I noticed from the OP's last post, was that his house water spigot was going to be located under the "stand", as in, a human may at some point, for some reason, place it's body underneath the vats of water to turn on the hose. And at no point will this human bump or...

In picture 2 the nameplate looks like its still on the cover just below the oil fill and dipstick. The model and ROC should be stamped into it. might need a through cleaning by the looks of it.

Amazon Harry Epstein CPO Outlets Menards Lowes

Those are actually a good price, Grilamid is an excellent material, many sunglasses that cost much more are made of it. Polarized lenses, made in the USA, what's not to like? How many of the cheap ones feature any of that?

Menards carries a nice selection of Made in USA Wilde punches.

Correct, straight from the Darex rep at FabTech.

You get him down on the price? I've been watching that one drop in price slowly.