Recent content by dgmpam

Does anyone know where I might find a jack release (Part# 988900) for a Blackhawk SJ-2 floor jack? Thanks for any help you can give. You can PM me at [email protected] if you prefer. Dave Marshall

Here is the picture of the Morgan Chicago 3-1/2S vise for the above post. Not the best pic but all I have right now.

The upload failed. Don't know why.

Here is a picture of the Morgan Chicago 3-1/2S vise in the above post.

Found an old Morgan Chicago vise at the local flea market with the only marking of 3-1/2 on it besides the Morgan Chicago. It has a toothed swivel base on it with a threaded rod down through the middle with a wing nut on the bottom. I think the rod goes through the bench surface and is tightened...

After measuring the bell crank pins, my jack is the J2 model. Hopefully, it is very similar to the J4 so I can reference things closely on the J4 information.

Got this old Manley floor jack recently. It was given to me, actually. I am trying to get some information on it. I am thinking it is a model J2, but am also wondering if it could be a J4. It still works and doesn't show any leaks, but the release mechanism is hard to work and needs some...

I was given this old Manley floor jack today. I believe it is the J2 model. It doesn't leak but the lowering mechanism seems to be a bit out of adjustment. Does anyone have any information on this jack? Thanks for any help.

I just obtained a Wilton bullet vise today, it was given to me for free. It has 3-1/2" jaws. The static jaw has 101160 on it and the dynamic jaw has 101161 on it. On the opposite side of the dynamic jaw appears to have 1W stamped in it. It has a date on the slide of 8-77. The outer ring...

Picked up this Baldor 620 with Baldor stand at the local flea market for $36. Anyone know anything about these grinders?

Sorry for the delay in responding, been away for a while. The bar ends were peened much like Kevin Scott described and then were dressed down in a lathe. It didn't take very long at all to do them and it made them look pretty good. Thanks. Dave Marshall

I could not read the date on the bottom. It was too faint to read. I tried everything I could think of -- even tried a younger set of eyes and that didn't work either. Dave Marshall

Here are a few pics of my recently purchased Wilton 9400. the swivel lock-downs were able to be fabricated with the help of information received from Kevin Scott. Thanks much Kevin. Dave Marshall

Just got my Wilton 9400 completed. I got a lot of help from information received from Kevin Scott on how to fabricate swivel lock-downs. Here are a few pics -- a before pic, some after pics and a couple of the fabricated swivel lock-downs. thanks Kevin for your help. Dave Marshall

Anyone have or know where to find swivel lock down nuts for a Wilton 9400 bullet vise? Thanks. Dave Marshall