Recent content by Diabolic

I want to purchase a PUMA compressor from NT. Anyone have a $50 coupon code?

The 4 cyl CH one has a made in USA motor and tank. It was a strong selling point. I'm not sure about the pump but it's cast iron.

I would really prefer to stay new because of the warranty. I really just want this for painting, and spinning an impact and rachet.

Yes it is sold as new with a 2 yr warranty parts and service. It's a 4 piston. I've never seen a 4 piston to my knowledge.

I think I'm going to pick this one up on Sat. Company has been in buainess for for 45 years at the same location. http://dallas.craigslist.org/dal/tld/4246187157.html

THank you for all the input! Basically I want to run the basic hand tools plus a spray gun from Eastwood. It's a HVLP that needs 12cfm@40psi. I would like to run a small air sander for wet sanding. I saw one called a Jitterbug I believe. SPECIFICATIONS • 12 CFM @ 43 PSI max. working...

Or maybe even this one, although Harbor Freight scares me. http://www.harborfreight.com/5-hp-60-gallon-165-psi-two-stage-air-compressor-93274.html

I'm trying to purchase a good air compressor for my 25'x25' garage/ I work on my personal toys, 93 Lightning, and 95 Bronco, a lot, and would like to do some limited panel painting. I was looking around and came across this really ugly looking, but good working 50 gal air compressor. It's an...

I need a good compressor for my new 625sqft 2 car. I would really like something that is as quiet as possible and would allow me to run a DA for some hobby paint and body. I definitely want to go with an upright design and an oil less model. I see both single and dual piston compressors. I...

Just an update......It's all up and running well. 2-2-2-4 cable in 2.5" conduit. I installed a 12/24 Square D QO sub panel with a 100amp 2 pole breaker. The 200 amp home panel now has a 90amp 2 pole breaker. I came right through the wall and into the back of the panel in both the house and...

Ok, I returned the 100, got a 90, got a new box with a built in breaker for the garage. I killed the wiring under the house, ran it all in 2" conduit and went straight through the outside wall directly into the back of the 200amp box.

Yes it has a yellow stripe. But once it's cut it's paid for so it's still going in. Not getting inspected anyway and this garage will never, ever be at anywhere near 100amp load. At most it will have a welder and window unit running at the same time. The funds have been cut off so it is what...

The wire I have is 2-2-2-4 provided by King Wire and Cable. It's Amp rating is 165 out of conduit or 120 amp inside conduit. Does this mean that the 100 AMP 2 pole I have for the house will work ok? The wire will be coming out of the ground underneath the house. The house has a concrete...

So do they make a box for the garage that has a built in 100A breaker or do I just add that? I will swap the 100A Home line for a 90 AMP. I'm going to un the wire under the concrete footer of the house(Pier and Beam) and then up the base plate right into the bottom of the 200Amp home box...

Well after reading the replies I may be returning some stuff. I completely did a 180 and bought 100 Amp 2 pole home line breaker for the house box 8/16 Square D box for the garage, but its not the home line 75' of the Southwire 2-2-2-4 AL Direct bury cable. Now I won't need counduit. I dug...