Recent content by DIYNY

yes, it's much harder, i use pocket screwdriver to pry it out

it's all good but far from perfect solution. it's PIA to remove sockets.

They are NOT exact reproduction. They are coming from the same taiwan factory. Like these ones too. sunex or grey pneumatic also had them i think?

As others have mentioned, combine those PT sockets with 11mm or 7/16 ratcheting wrench and that will give you about 17-18mm height. No other socket/wrench or socket/ratchet combination comes close. Yes, Koken Zeal 1/4 sockets are shallower by 2 mm but they don't have hex base and therefore can't...

Basically he needs something like this but with a detent ball instead of a magnet. I have been using 17mm wrench with nano sockets for over two years now and I find that I rarely need any socket retention. And it's easier to switch sockets or remove a wrench and spin socket off by hand when...

none of these will work for the purpose he wants, they are not flat where 3/8 drive tang begins.

either buy titan set i linked above or do what this guy did.

If you wanna go cheap way, here is the way: Buy this astro nano set and then get this wrench and this adapter set. now you have 6mm-24mm sizes on super long flex head wrench. Imo much better option than buying Kabo set which skips sizes, is flimsy and has questionable warranty (except Icon)...

is that because of teeth not being cross hatched? you got me interested here coz i've got that pair

You need this. I have 3/8" version of this. Then you stick it to one of your 11mm hex sockets. Not an ideal solution but it works.

i'd try to stick needle nose pliers into gaps. if that doesn't work then comes out dremel with a carbide bit.

Mike please add Koken 3756zs to the inventory. Thanks!

definitely malco eagle grips here

one of the options is to get this. usually it's $25 on amazon, then you can link either 21mm wrench or 1/2 breaker bar to your existing wrench.

IMHO the best way to remove a broken bolt