Recent content by djrumz

Hello everyone I have a STAR floor scrubber with a kawasaki propane engine on it. I had to replace the plastic cam gear which broke with a metal gear. Put engine back together and ran it once for 4hrs with no issues, went to lunch came back got on scrubber and all it will do is crank over but...

Hello everyone I have a STAR floor scrubber with a kawasaki propane engine on it. I had to replace the plastic cam gear which broke with a metal gear. Put engine back together and ran it once for 4hrs with no issues, went to lunch came back got on scrubber and all it will do is crank over but...

Hello everyone, I am looking for a part for my minuteman EX260, I am needing a recovery tank for my scrubber. I have a crack where the brackets bolt in to the tank, so I need a new one or someone that can plastic weld. I would like to get a used tank for cheap please let me know asap for you...

Hello everyone, I am looking for a air motor for a 10 ton Snap on floor jack YA662, having a hard time finding one. If you have one or know someone that has one for sale please let me know the price and how good of shape it is in. Would like to have a brand new one.

hello!!!!!!!!!!!!!

I would go with a light compound, Meguiars ultimate compound is what I use.

I have an enerpac p80 hydraulic hand pump "OLD" that I put a new tune up kit in. I also put a new 10,000PSI gauge on it, now when I jack it up it goes up fine until I hit 4,000 PSI then the handle gets hard to push and once I let go the PSI starts to drop slowly. What could cause this to happen...

I have a 1" IR 271 impact wrench and it leaks air out the exhaust a little, so I put a tune up kit in it and it still leaks air a bit. I have took it apart 100 times trying to find out what it could be but cant find any thing wrong. Please help!

Hello everyone I have had this old blackhawk S4 and I put a seal kit in it and it now does not have a high speed when jacking it up. Well I found out the bullet is not seating in the slot so I put a ball in there and then I had high speed again but it was hard to jack up under a load. So I had...

Hello everyone I have a 2 ton blue point floor jack and I need a parts breakdown and a seal kit but I cant read the model number could someone help me out with this please?

Hello everyone I have a Walker 93660 floor jack and I am having issues with it. I replaced the seals in the power unit and replaced all the balls and springs, now when I jack it up it goes up fine but when I move the handle up to pump again I can see the front of the jack drop just a little...

Hello everyone I have an old Blackhawk S4 jack and I put a seal kit in it which had a lot leather seals, so I replaced them all and now the high speed does not work it will jack up but really slow. Could someone let me know what could be wrong here. I have been trying to adjust the packing nut...

I have a YA 700 snap on floor jack does anyone have a parts breakdown for this jack? Could you please send it to me or show me on this page please.

The second one is just like the one I have here, have you put a seal kit in either one of those? If so let me know how you did it please 930dreamer.

yes it has a headlight