Recent content by dlewis

Call Amorpoxy and ask them, that piece your referencing has a buffer drive and would not work on an Edco grinder. The rental place should have dynaserts that will do the same job for cheaper than that attachment.

Do what ever you have to do to get the 8' door.You can't fit a SUV or truck in a 7' for yourself or when selling down the road.

Welcome.Looks good Hard Charger.

Theres a plant on E.State St. We rent them equipment all the time.

Trane plant Trenton,NJ

I got this set up for $75 with the filters,one pre filter and one softener cartridge.I mounted it to an old hand truck.It will do about 900 gallons before you recharge the softener cartridge by soaking overnight in sofner pellets.

Check acwholesalers.com thats were I purchased mine some good deals somtimes before it gets to far into the season,like last year models.

Most truss places if your buying the beam from them will calculate it for you.

Depends what tools you have at your disposal,hole saw the finish the corners with jigsaw.

Got a pic of the die head your using.

When big retailers close stores they sell the contents to a liquidater who controls the discounts.

Air hammer

Good choice!:thumbup:

I made one out of 1x6 with picture frame moulding to hold the plastic sign in,used two single T-12 fixture I should have mounted them on the sides shining towards the center because it's a little bright in the middle.Also don't forget a couple air holes.

Did you call them.