Recent content by dtenney

It really does feel that way, I am open to suggestions for improvement, too bad I did not take the time to research first and do it right the first time. -David

I would rather do it right

I agree, any recommendations on fixtures?

No dimming function on these square ones. But I did buy one of the round models, with dimming function: https://www.1000led.com/product/182/45w-led-round-slim-canopy-light-120-277v-10-year-warranty I hooked the light up without the dimming wires and the glare was slightly less than the square...

I am starting to think that canopy lights are not the right solution for a 10ft ceiling height

https://www.1000led.com/product/27/45w-led-slim-canopy-light

The lens are clear. See attached pictures. One shows the OEM lens and the 2nd picture shows a couple pieces of film I tried inside the lens. The film I tried did not reduce the glare enough, but possibly a darker film would.

I recently hired an electrician to cleanup the wiring and lighting in my shop. I decided to install new 45w LED slim canopy lights vs retaining the old 4' tube fixtures(which I had converted to LED). The electrican ran new conduit and electrical boxes per the attached sketch. E marks each box...

Husky 80gal single stage, 14cfm @90psi, 155psi max http://www.homedepot.com/p/Husky-80-gal-3-Cylinder-Single-Stage-Electric-Air-Compressor-C801H/203187346

The shop came with the house, shop was built in 1980, I got lucky. :-) So outside it is.....copper or iron pipe??? I am leaning towards iron pipe....thinking 1" main line (due to line being 110') with 3/4" drops?

Setting up my first garage and thought this forum could get me headed in the right direction. The garage is 7000sqft on 1st floor and 5000 sqft on 2nd floor, the 2nd floor is not shown on the floor plan below and will only be used for storage. I am in the process of finishing the install on my...