Recent content by Dtraster

I have a the same set. It's missing all but two taps. I'm glad to see the photo of the catalog. Thanks for that.

I need to make a handle for this 2” chisel with an odd “tang” that’s larger around than any I’ve ever seen. 5/8” diameter but fairly short. 1-3/16” long. There are no markings to identify the manufacturer. Not sure what the handle should look like.

Vintage Lufkin 60-inch ruler with brass ends and a hook. A little hard to read but I think it's a No. 714-3 (found an image of a 72-inch No. 714-4 ruler on line so I think mine is a 714-3.)

I have an older Senco Model L Brad Nailer. It blows air out the top all the time. I assume that I need to replace the o-rings in the trigger assembly but I cannot figure out how to remove part no. CA0065 from the housing to get to the o-rings.

Good ideas. Thank you.

Thank you. I looked at that site before posting here and didn't see anything. I just sent them an email.

I posted this in the wrong thread earlier today. I have an older "Corona" hammer that would be soft faced if I could find threaded replacement tips with 5/16-24 threads. Any suggestions?

I have an older "Corona" hammer that would be soft faced if I could find threaded replacement tips with 5/16-24 threads. Any suggestions?

Interesting thanks for the info.

Thanks for flipping my pics!

Agreed.

I can't find any identifying info. Anyone know who made this? I need to order a replacement jaw. (Can probably find one that will fit if I look hard enough.)

I have a Columbian bench vise that is welded together, not cast. I don't know whether it's something special or a waste of perfectly good metal. Anyone know what this is? Sorry the photos are upside down. Can't get them flipped.

So, update my from Single to Two stage and 220 not 110. I like the idea of buying an older used compressor. In fact, that's probably my preferred approach. I just haven't seen one on CL recently. I'd worry a little bit about the tank being rusty... is there a way to check to make sure the tank...

Looking for a new air compressor for my garage/shop. Any advice would be appreciated. Major uses: Filling tires; Blowing dust; Staples, brads, and finish nails; I own a framing nailer but don’t use it much; Occasionally use a small air hammer to chip cement; I have sand blast cabinet that I...