Recent content by durk_2007

I know this is an older post but have a similar situation and could use more eyes. I'm installing a filter system and trying to figure out the best way on a well, my thought was Shutoff=check valve=spin down (40 mic)= T to outside spigot= 3 stage canister (4.5×20)= pressure...

What brand of solar inverters do you have? No, your lag will barely be noticeable. my system will switch over in 50ms and I have enough battery to run essential loads for 4 hours. Running off 6kw solar and when batteries get below 50% generator with start up to recharge batterys. Not Tier 1...

I'm at the same stage of building, I house wrapped the girts before metal sheeting then put 1.5in foam board between the girts. I was about to special order the Menards post frame insulation until I did the math and realized their john Mansfield mineral wool R23 is cheaper per sq ft with bulk...

Is this for a shop or a multi room application? If it's for a single room with similar length loops the flow controls really aren't needed and a simple copper manifold would be much cheaper.

When I called my AmFam agent to add my shop she asked about wood stove. I asked what it mattered and got the response that they will not insure any building with a solid fuel heat source INSIDE and door capable of vehicular access due to combustable fumes

I work in a dealership with 20+ glass doors. They are all single pane. The largest things to watch for is the panes getting loose in their frames and hail/ debris breaking them in storms. We replace about 10 panes a year due to storm damage. Also consider the bottom and TOP panels being solid

From what I have seen these are mostly for finding defects in paint jobs. (Dirt nibs/ hail dents)the multiple angles of lite help to run over different curves of a vehicle. Kind of like the lights Paintless dent guys use

We just did 600sq ft with 3 guys in about 1.5 hours. 2guys raking to level till it was close then pull the screed 10ft once it was screeded 3rd guy hits it with a float while first 2 are raking next section. Floater can help with screeding while waiting. Once bleed water is gone get on it with...

The high end "warm board" hydronic company uses space pac AWHP for their systems. that gives me a little more confidence if they are willing to put their name to a partnership

I'd love to plumb it from the existing tank. it's just that it's over 200ft thru trees/sidewalk/driveway and buried electric. I just don't have the gumption for that. It's just for backup heat and hot water at a slop sink.

The fitting at the small tank (receiver) has a valve that can be used to purge pressure and vapor until it's full of liquid. The main thing I'm trying to figure out is do I even have the proper connection on my tank to do it before I spend the money on the hose kit.

I have a 500gal tank for my house and 3-100LB tanks for my shop. (The way my property is arranged I really don't have a good place to set a tank away from building) so multiple small tank it is. They want $1 lb to fill the small ones at the service station or $.50 to deliver to my tank. So I...

Here's a thought, my paint booth doors use large magnets (think magnetic tool holder bars) to hold them closed even with a strip of soft foam between the door and jamb. And those finger seals on inside and out to keep the bottom sealed. Maybe look into paint booth examples to find a good sealing...

For anyone looking for more inexpensive quality I've had great success with SUNEX tools

Look at the mirror on an alignment rack convex like a hospital hall