Recent content by Ed E

I would agree with Billconner. Run #4 copper or #3 al for 60 @ 240V. Distance is a factor in amp ratings for wire. Then later if you want a light welding setup or other higher amp draw device(AC, etc) your good. Size the 3rd sub panel with the room for additional future breakers. Oversize the...

Running out of room for a metal lathe.... Just finished the short roll around table for the bench top drill press. :-) Thanks Shiftless, I'll try Frank Lee for the pulley.

I appreciate the humor. Just thought this might be resolved easy. Couldn't find anything on ebay. I have decent shop. Fabbed up a center speed reduction setup for the bench top. Pretty cool. Can't stand the spindle pulley wobble but didn't intend on making a pulley from scratch... :-/ Just got...

Hey. New here. Hope I'm posting in the right location. Trying to find original or source an aftermarket spindle 4 step pulley for an old Craftsman drill press. Model 103.23100 The part number for the pulley is 18019 according to the info I have. The bore appears to be 15/16" Its been spinning on...