Recent content by elite1

Hi Topcok88, Rustoleum recommended sanding down the sharp areas where the bubbles occurred. Once flush, recoat. I was working on the floor today changing some rotors and pads. I pressure wash the wheel wells when I do this and the floor was a little slippery. When I recoat, I'll throw...

This probably great advice! I did not use primer and if primer would help with sealing the slab prior to coating, i would only imagine it preventing the bubbling that sporadically appeared.

Smell disappeared within a day or two. Bought a new car this past weekend and needed to wax it. The shiny reflective floor blinded me for the rear end of the wax job. I also inquired to Rustolem on the coating. They will send me a replacement coating for the bubble situation. I'll need...

Nice job! I would be satisfied with this result!

Whole house attic fan would help. Just make sure you have attic ventilation. Turn this on and, you would evacuate all garage air within a few seconds and would cost pennies to run. Just a thought. Cheaper than A/c.

Turned out beautiful! Thanks for sharing! If you use this sealer, is there a concern with overcure? Will this turn yellow over time?

Perfect! I used to use a single part epoxy and this didn't last. I'd repaint every month to maintain a perfect floor. This, should be perfect for a long time. What prep work was involved prior to paint application? Like the idea of Sikaflex for contraction joint filling. Within 24 hours...

Tile! Cool video regardless. Thanks for sharing! I would cringe any time i use a jack on tile.

Left two windows open in my Daily Driver overnight. Epoxy smell soaked inside the interior. Floor looks cool. Does racedeck flooring emit the same smell? Its all plastic right? The vapors I experience today, may be coming from the freshly laid floor and may disappear with time.

Look forward to the photos! Nice floor by the way! Have you tried it wet since your clear coat install?

Love the clear coat! Just a personal preference, Walls need a little paint though.

Floor looks good but, collects dust easily. Giving it a week before i make my mind to fix and keep or, replace with something else. Bubble edges are sharp regardless.

Finally finished but, frustrated. -Spent a lot of time with Prep work. Rented floor sander, filled joints and diamond ground them flush. -presoaked and etched. Pressure washed clean and let dry for 24 hours. -Ended up with cement gassing causing bubbles. Tried to roll over them as the...

Wow! Tell them to keep working on the rest and restamp it all. I can tell from you photo but, could you refinish this trimwork?

Lots of prep work over the past two days. Used a Grinder cutoff disc to cut the joint wood off. Also repaired all wall holes for prior owner.