Recent content by erervin

Recently applied Armorpoxy’s Armorclad master kit on my 26x26 garage floor with the Topcoat layer. Very please with the end-result. Used 18” rollers to apply the primer, epoxy and topcoat. Each layer took ~90-minutes to apply. Sent from my iPad using The Garage Journal mobile app

Correct. I wanted to be able to powerwash the floor and not worry about water causing premature issues with the wood framing, thus I went with a 36" footing with a 12" stem wall. The 5" floor was poured after the building was up and was tied into the stem walls with rebar and wire mesh. The...

Because the stem wall was thinker than the wall itself, I had a custom piece of angled trim adhered to the top of the stem wall to give a more finished look.

Wrapped up the project today. Ended up going with ArmorPoxy’s ArmorClad 3-layer floor coating. Still have some dirt work to do outside but ready to enjoy it.

Here is the beige ArmorPoxy installed.

So I’m about to apply the ArmorPoxy Ultraglaze 1-part clear topcoat tonight after applying the epoxy last night. Is this what you are having problems with? Makes me reconsider. Correction, I see the SPGX is different than the Ultraglaze.

Looks great. I ordered the beige color and it’s going on this weekend.

Looks great! I’m starting my ArmorPoxy project this week and went with their beige color. Going to start the etching process tonight. Looks like you used an 18” roller, that work well to apply primer, epoxy, and clear coat? That’s what I’m planning to do. I went with two 600 sq/ft kits and...

First post on the forum, so thanks. Nearing the completion of my 30'x40'x10' garage with corner porch here in eastern Kansas. Worked on the design for several months before pulling the trigger, here are a few of the design components: - 2 10'x8' overhead insulated doors - 4 4'x3' windows -...