Recent content by expensivehobby

  1. E

    1950`s Delta DP

    Good idea! Thanks
  2. E

    1950`s Delta DP

    Thanks Guys. I have released the lever trying to rotate the head slightly to align it to the base. It does not move;must be stuck after all these years..thankfully!! I`ll purchase a colar as stated above and proceed cautiously …EH
  3. E

    1950`s Delta DP

    Can anyone tell me if the head of my drill press is adjustable raise/lower? Also,if so, is there a stop to prevent it from plummenting into the table?….Thanks
  4. E

    Cuttler Hammer

    The drill press is 120vac 1956 Delta/Rockwell…it has a toggle switch on the motor & now will have this Cutler switch mounted on the head for a more convienent & safe operation.Thanks to all for your input….
  5. E

    Cuttler Hammer

    Not sure what a momentary switch does? I`m thinking start/stop until function is switched from one to the other? Thanks for the replies, un fortunately I have to go to work now!
  6. E

    Cuttler Hammer

    It has 4 terminals, two for each position
  7. E

    Cuttler Hammer

    I bought a start/stop switch & need a wiring diagram to show how to wire into a vintage 1956 Delta DP.Any help would be appreciated….EH
  8. E

    Delta Rockwell DrillPress

    Found this site & ordered the proper belt..Talked to the guy on the phone and he knew exactly what I needed....https://www.beltshed.com/default.asp Packard V8, just wanting to get the best results & a smooth running machine!
  9. E

    Delta Rockwell DrillPress

    Grainger was/is a dead end!
  10. E

    Delta Rockwell DrillPress

    Thank you for the response..I have actually ordered one from Grainger, will see how it turns out! They had a cross reference # ? $11.00 plus shipping.Certainly appreciate the link to the specs on the Delta site..
  11. E

    Delta Rockwell DrillPress

    I`m in need of a new belt for my 15" 1956 Delta drill press! No luck locating one...# 49-168. Any leads appreciated.....
  12. E

    Delta Rockwell DrillPress

    zkling, it is a 1/2 " chuck...thanks for pointing that out!
  13. E

    Delta Rockwell DrillPress

    http://www.garagejournal.com/forum/attachment.php?attachmentid=290163&stc=1&d=1382890529http://www.garagejournal.com/forum/attachment.php?attachmentid=290162&stc=1&d=1382890529 Bellefountaine Years list: serial # 118-8825, the model # is a mystery, so far...15" 1/2 Jacobs chuck!...
  14. E

    Delta Drill Press Parts/questions

    I`ve been looking for a model # on my 1956 Delta Rockwell 15" drill press!any help location it would be greatly appreciated....Thanks
  15. E

    Delta Rockwell DrillPress

    Is there a model # for these ? I have a 1956 by serial #, looking for model # too?Thanks
See more
Top Bottom