Recent content by eystein

Looking Good !!! - Will the FordBarn be upgraded as well ?

Bump

Bump

Bump

Looking for a miniature English Wheel like the one shown in the picture. Intended use is final smoothing after dent removal in stainless steel sheet metal.

I live in Norway and always get fed up by all this talk about energy efficient bulbs. Outdoor OK, but here where it is cold most of the year any change to a more energy efficient indoor bulb will only make the thermostatically controlled electric heater work correspondingly harder. - No gain !

Are the smoked lights equipped with amber bulbs inside ? Do they turn out amber when in operation ?

Building into a hill is exactly what I am thinking of as well. Find this thread very useful.

Awesome thread ! Hope to see more of the finished project in the future !

Did you consider 2-post lifts ? I find that the 4 posts sort of get in your way while working.

I have a garage where the ceiling is made up of lightweight porous concrete elements, where some of the surface started chipping off and falling down on the car below. Fastened wooden slats to the ceiling with 6in special lightweight concrete anchors, and covered the ceiling with plasterboard.

Amazing Garage and Props. I particularly like the vintage air compressor ! :-)

I recently aquired an old Meddings Pacera (English) drill press. Underneath and inside the main body, there is a toothed sector of about 45degrees, which has (to me) no apparent function. The sector teeth will engage with the gear on the axle for the lever which lowers the drill bit. However...