Recent content by feb80

Drivesitfar - After review I would tend to agree with you that a threaded sleeve is needed. I did come up with a solution, as I have no idea where one would find such a sleeve. I purchased a 3/4" shaft collar with set screw and some machinery bushings. Slid the main screw into the...

Drivesitfar - here are the pics of my vise. Guess I don't understand the drive sleeve you are referring to and where its located.

Here is the link to my original post with the pics of my 05195. http://www.garagejournal.com/forum/showthread.php?t=354704&highlight=craftsman+0595. What would be helpful is a pic or schematic with the eclip you mentioned. Does it slide into the threaded sleeve? For sure we did not find...

Hello everyone! I was referred to you guys for some help by one of the senior members of this forum. My dad passed away last March and while going thru his belongings I found a Craftsman vise Model 05195 - 3 1/2" I would very much like to get this back in working order but know very little...

Hello everyone! I was referred to you guys for some help by one of the senior members of this forum. My dad passed away last March and while going thru his belongings I found a Craftsman vise Model 05195 - 3 1/2" I would very much like to get this back in working order but know very little...

You are correct! Upon further review ( some additional wire brush ) the number is actually 05195. I would like to find a schematic to identify the missing part.

Hello everyone! My dad passed away last March and while going thru his belongings I found a Craftsman vise Model 0595. I would very much like to get this back in working order but know very little about these things. The jaws on the vise do not open when you turn the screw - but they do...