Recent content by fin5281

Outside temp is in the 30s. I am happy with a a 55 degree ambient temp. It would get hotter if I turned it up but have not yet done so as I'm still fine tuning the system. Sent from my iPhone using Tapatalk

My builiding is 40x40x16' Insulation is moderate and I have high cielings. I can maintain 55 degrees no problem just seems like the pump runs all the time. With the setup I have i wish there was a way to make it run less therefore not running the high amperage of the boiler continuously. I am...

Water. Will have to check out the path but I think your right that i need a bigger pump. Out of curiousity.....I have an old bell and gossett laying around. Would having 2 pumps on the same main be a possibly to increase flow? Not sure if that's do able. Just to try it out before spending...

Ok been running the system for last 2 days. Outside temp is 30. Inside temp up to 48. Supply side is at 120 return side 80. So my delta t is 40. Any suggestions how to get that delta number closer to 20? Sent from my iPhone using Tapatalk

I knew I got those numbers somewhere . Just could not remember. Any suggestions to get me closer to that 1.2 would be greatly appreciated Sent from my iPhone using Tapatalk

1" main. That's what is so confusing to me Sent from my iPhone using Tapatalk

What would be a good gpm to target? Sent from my iPhone using Tapatalk

Yes it is a 3 speed pump. .6 at the fastest speed. .4 at lowest Sent from my iPhone using Tapatalk

In temp 100 return 60. Did not allow to run for a long time cause I was not sure my flow was working correctly. Sent from my iPhone using Tapatalk

Yes. Balanced and air removed. I ran if for 2 days Sent from my iPhone using Tapatalk

New Picture attached. Hopefully it is not sideways

Sorry the Pic came in sideways

I am beating my head against a wall here. I can only get .6 gpm out of each loop on my 6 loop system. Loops are in the neighborhood of 270 ft. Longest is 272 1/2" Pex. The pump I am using is Grundfos S15-58 which by all accounts should be the correct pump for my system. Take a look at my...

I am heating the building with radiant floor. Spacing for trusses is 4' OC. No soffits. Just a single ridge vent along the whole peak of the 40 ft roof. Metal roof Sent from my iPad using Tapatalk

Leaving wide open Sent from my iPhone using Tapatalk