Firebrick43's latest activity
-
FYou ought to be able to find a good used 1970s era General Electric Elec-trak lawn tractor for less than cost of a new motor and...
-
FFirebrick43 replied to the thread Why don’t pullers use acme thread screws?.The lower angle Acme threads are specifically used in manual machine tool axis, jacks, lifting devices, linear actuators, and air craft...
-
-
FFirebrick43 reacted to LopezBart's post in the thread Why don’t pullers use acme thread screws? with
Like.
Likely because ACME threads are too coarse. Most pullers use fine threads, providing far more force. -
FFirebrick43 reacted to HoosierBuddy's post in the thread Does Radiant Floor heat make sense with Like.
That's not my experience. What water temp are you running?
-
FFirebrick43 replied to the thread Correct Use of Self-Grounding Outlets?.Self grounding outlets "MUST" have the yoke to touch the box/mud ring mounting flanges. 250.146(A), If not you need a separate bonding...
-
FFirebrick43 replied to the thread Does Radiant Floor heat make sense.Buildings with good solar gain (south facing windows) can have issues even with a floor stat on sunny calm days. Probably not an...
-
FFirebrick43 replied to the thread Does Radiant Floor heat make sense.You haven't looked at hardly any installations then? Almost all of it is put on the bottom with little issue. Either with snap in...
-
-
FGFCI is never going to play well with a VFD setup like that. I had similar issues with a diamond wheel/solid carbide scraping tool...
-
FFirebrick43 replied to the thread Stihl fs55rc.Why wouldn’t it? Do you push the trimmer away from your hip to the side 6” or more? I have experienced a mild kickback when a half...
-
FFirebrick43 replied to the thread Stihl fs55rc.They kick back worse. That is why handle bars are required
-
FAll minis in the install manual and brochure state max line lengths and height difference. As for as different size evaps when i bought...
-
FFirebrick43 replied to the thread Working with an old wonky building made from fieldstone.Do a stucco finish on the inside and level it with the scratch coat?
-
FFirebrick43 replied to the thread Wood Stove: How many cords?.I wouldn't go with a 372 as a main saw. I have a 362 stihl which is comparable to the husky 562 and sometimes I think it would be...
-
FIn the first image you have above the first endmill looks to have chipping.
-
FFirebrick43 replied to the thread Wood Stove: How many cords?.Depends on the house. We have a tiny Jotul F100 stove and it heats our 1450 square foot house just fine although its going full bore in...
