Firstram's latest activity

If I didn't trust #kmscott so much, I'd assume an AI edit in there. Things just look a little off in the second and third pics.

Never will be up to your level but I enjoy booting around on my new DiamondBack.

whatever gets you outside and pedaling around is a great bike!

That’s crazy! Exposed screw no less.

That looks grea! If you do want to go smaller, drill the hole in oversized stock then cut it down concentric to the hole. You can safely...

I ran another ~10” scrap test piece through, removing As much award as possible every inch or so, and really picking at it instead of...

Mystery solved! Yep, it was almost certainly moisture from pores in the cast iron- and presumably a little "dirty", still, from the...

You inspired me to take my one eyed *** out into my shop and finally start cleaning my Ex-Cell-O mill up. I scrubbed it for about 4...

I hope you’ll share the stl, that’s awesome!

yup. I have a different design im working on that should be stronger. but the concept is there. im stick of these stupid things...

I cut some blocks from a scrap chunk of maple, then drilled 5/8” holes. 1/2” ID x 5/8” OD bushings are a tight fit. Long 1/2”...

There is a technique using a miter locking bit to make a square post. I've done it a number of times. I snagged this picture off the...

Is it big enough to tap 1/8 NPT? You could step up from there.

Right turns are iffy, you gotta keep the scooter straight and lean your body to the right. The drill is kinda nice down there because it...