Recent content by flemrasm

  1. F

    AEG tablesaw - help needed

    Hi All, don´t know if this really belongs in the vintage tools section, its only 36 years old though :-) so vintage might be a stretch i just purchased this saw, and would like to find some more info, the motor is missing and i would like to replace with the correct one, the brand is AEG (...
  2. F

    The SK Tools Giveaway...

    count me in Flemming
  3. F

    got lucky - i think

    small update, turned the cross sled from this over this to this weather hasent been the best so progress is slow, working on the apron and lead screw now, the lead screw is in pretty ad shape, I hope I´m able to bring it back to life regards Flemming
  4. F

    got lucky - i think

    Its 3 steps for double pulley Flemming
  5. F

    got lucky - i think

    headstock done & in place tobucket.com/albums/z243/flemrasm/IMG_20160109_154920007_zpswypsv2bc.jpg[/IMG][/URL] started on the removable piece of the bed & the cross sled & chuck I have been searching on to fint the make of it, and it bears some resemblance with rossia lathes, but not...
  6. F

    got lucky - i think

    Hi Steevo, that trailer jack is sweet, I need to copy that, thanks the drill press is close to finished now, installed the motor - a deplacement as the original was 380v and i only have 220v in my shed - its just powerful enough to run it, but ill keep lookout for a more powerful motor :-)...
  7. F

    powder coating lathe gears?

    thanks everyone for the answers, I´ll keep the teeth oiled instead, the only thing I have a problem with is the constant temp, where we live now, I have a small un-isolated shed, and as were renting that's what I need to settle with for now, the Danish winter is tough on the tools, but ill just...
  8. F

    got lucky - i think

    thanks, I've refurbished the legs and are working on the bed, so far not a single sign of any make :-(, the headstock is next, everything is rusted so I need to take it apart, there are a few features that I would think could give me pointers towards the make, but so far no luck. regards Flemming
  9. F

    got lucky - i think

    I´m a novice with regards to milling, I would primarily use this for Aluminum, would you say it better to use the lathe once I get this set up? reg. Flemming
  10. F

    powder coating lathe gears?

    Hi, moving a bit further with the restoration of the drill press and lathe http://www.garagejournal.com/forum/showthread.php?t=304323 and I have a question, since everything I clean the old grease off starts to rust imidiately in the damp Danish winter, I´m thinking about powdercoating stuff...
  11. F

    got lucky - i think

    Should I use google translate? I know my english is not perfect, and i am sorry if that offends, I try my best Flemming
  12. F

    help needed, remove drill press spindle pulley

    Are there any tricks, can i put a piece of iron under the pulleyto avoid breaking it? flemming
  13. F

    got lucky - i think

    Didnt think of that, makes sence:lol: thanks Flemming
  14. F

    got lucky - i think

    Thanks, i'll keep that in mind, can i use wax on the pole as well, right now i just covered it with oil Flemming
  15. F

    help needed, remove drill press spindle pulley

    Hi folks, thanks for your answers, no set screw to be seen, im thinking it might be tapered I well get a hold of a puller and try Reg flemming
Top Bottom