Recent content by Fudog

I was given a craftsman red racing style 1.5 ton floorjack from my father and I have tried everything to get this to pump up but not having any luck. I don't have an owners manual and the jack is probably 6 years old. has not been used much. Confused ?:confused:

I would look at the Klein MM5000 or 6000 that are made in the USA and have an excellent DC accuracy.

I thank everyone for the input and I will be putting a dedicated circuit in with a 20 amp breaker. Thanks!

Should a microwave oven have a dedicated line with a 20 amp breaker? I just replaced our old microwave that went bad with a whirlpool convection microwave and now the breaker trips when using the convection oven. currently there is a 15 amp breaker with 14 guage wire. Also on this circuit there...

What happened to the Craftsman 20 volt drill? I have not seen it in sears for a while?

What is the Multimeter or Clamp meter of choice for HVAC Technicians? Thanks!:beer:

I have a Ford Ranger that I am considering buying a Wea:beer:ther Guard tool box for and would like some opinions on these. Thank You

I purchased the Power Probe 3 and LOADPRO Test Leads as well as the Fundamental Electrical Troubleshooting book from Amazon a couple of weeks ago. The book is excellent.

Snap On makes excellent tools but if you take out the middle man such as the Driver/Salesman in the tool trucks wages the price on these quality tools would drop somewhat and start some outlet stores nationwide sales would probably skyrocket. Just another angle to look at. Thanks!

Good Evening, I am looking for a good hose torch for my propane and mapp gas cylinders with about 8ft of hose for getting into tight places. I tried the self igniting Bernzomatic from Lowes and did not like it as it would not stay on and I did not like to have to hold the trigger constantly and...

This is electric radiant ceiling heat with a thermostat on the wall.

I have one small bedroom that has radiant ceiling heat that will not work. How can I test the thermostat to see if that is the problem? If the thermostat is OK what is the next possible cause? I know this is a bad source for heating and I do not see much information about this. Thanks for the...

Good morning, Does it really matter if a 75 or 100 watt bulb is used in a standard 1 bulb fixture that usually has a 60 watt in it? Thanks:dunno:

Good Morning, I have an outlet that only one half worked so I put a new outlet in and everything was fine and then I decided to put a GFCI in. I took the outlet out and installed the GFCI. The circuit breaker from the panel is 20 Amp and all of the outlets were rated at 15 AMP. I should also...

I have a Craftsman 1/2 in torque wrench 25-250 ft pounds that recently gave out in the way that I can no longer see the torque setting through the window on the handle and this is the third one I have had within the last ten years but I have decided to look for a flex head 1/2 in 25-250 ft...