Recent content by fuelie74

I ran cat5 underground to mine twice and soon to replace it with fiber. The first time I replaced it was due to a lightning strike. It struck the ground between my house and shop. Fried everything connected to the wired network and ruined the cable. By what I understand if I would have had fiber...

I run a 1972 Champion that I got used and replaced the motor. If the time ever comes to replace it I will buy another Champion. As far as requirements to me you want a two stage pump and it needs to be a low rpm pump. The cheaper units speed them up to get more CFM, all that does is make them...

When I insulted my pole shed I stapled house wrap between the post from the inside then used fiberglass Batts followed by plastic for vapor barrier. I couldn't be happier with the results. Sent from my SM-N960U using Tapatalk

No I am in need or replacing the green amp clamp cable the has three shielded pair of wires. Sent from my SM-N910R4 using Tapatalk

I just picked up a VAT 40 that is in fairly good shape except for the wires on the amp clamp. The clamp it's self is in good shape so I was hoping it just replace the wire. Does anyone know where I can pick up the wire to repair it. Haven't had much luck serching for it. Thanks. Sent from my...

What are the alternatives for the tube? I put my old buick distributor in and it strobe but then the strobe got faint and went away. Sent from my SM-N910R4 using Tapatalk

I have always wanted a Sun Distributor machine and found one today. It's not in perfect shape but both motors work, everything is free and I didn't pay a whole lot for it. My play is to fix it up and learn to use it. I can't find any information on this model number so I am not 100% on the...

Yeah they are insulated comercial doors Sent from my SM-N910R4 using Tapatalk

I stuff foam strips along the door when not in use but, the problem is I open one of the doors at least every couple days working on people's cars so I need something quicker. Sent from my SM-N910R4 using Tapatalk

Has anyone ever thought about putting a second door on there overhead door openings for the winter months. I have a 12x12 and a 10x10 facing the west and the cold wind is hard to stop even with seals on my doors. A sliding door won't work on this building so I was thinking about some hinged by...

SKF, National, or Timken is fine for most vehicles. It the vehicle uses a magnetic seal on the rear of the bearing to rear wheel speed SKF only. I have been burned many times by National bearings not having a strong enough magnet to read. Sent from my SM-N910R4 using Tapatalk

It would be nice to mount the compressor in my mechanical room in my loft so I wouldn't have to listen to it and not have the bulky tanks in the room. My original idea was to mount the pump in the loft in the back of my shop, come out of the loft with 1" black pipe go up to the ceiling two...

Is there any advantage to mounting the pump remotely on a skid? Was wondering if remote mounting with 30ft or so of pipe would help with removing moisture from the system. Sent from my SCH-R970 using Tapatalk

Thanks for the help on this one guys I just got my parts this week and started redoing it tonight. How and where should the expansion tank go then if the why I have it is wrong? Sent from my SCH-R970 using Tapatalk

Is there any good reason to have the purge tee valves over just tee'S? Sent from my SCH-R970 using Tapatalk