Recent content by gaffobohs

Mac tools I think has the best. The Matco ones I have are still slippery when the knurling gets oil on it. Sent from my iPad using Tapatalk

The main thing to remember with a powerprobe is to know the circuit you are on. You can't shoot 12v up a 5v reference wire, or it'll be a very expensive mistake. A good DMM, loadpro leads and some backprobes and you'll be pretty set. Sent from my iPad using Tapatalk

Thanks! I did do a search but I never saw that thread! Sent from my iPad using Tapatalk

Thanks, looking at your thread and mine I guess there's not much interest. Sent from my iPad using Tapatalk

So working as a mechanic for the last 8 years I have accumulated a few homemade tools that make my job so much easier and faster. I've made harnesses for most abs sensors that are soldered to sets of DMM leads so I don't have to try get two probes in to test, Deutsch 9 pin connector harness that...

I bought them for work in a mechanic shop. First time I've ever seen drill bits bend! Brought them home for putting in wall plugs etc Sent from my SM-G900W8 using Tapatalk

I PM'd him yesterday but haven't had a reply. So disappointed I missed out on this kit. I posted in the wanted section but if any of you have any extra or if you found you don't use it, I'll very happily pay to take it off your hands! Sent from my iPad using Tapatalk

I know a number of you bought these kits off ArchiesToolShop. If anyone bought any spares or has one try don't use or is collecting dust I'll very happily pay to take it off your hands. Thanks Sent from my iPad using Tapatalk

Anyone know if we can still get these? Would use these every day in work. Sent from my SM-T350 using Tapatalk

Yep, have a brushless makita one in work I use daily! Like you said, really don't know how I worked without one before! Sent from my iPad using Tapatalk

Been wanting to pick up a drill for work so took a trip to home depot yesterday. They had a special buy on a non hammer drill for $99 which I was going to get until I spotted this set for $220. So got an extra 1/4 hex impact and extra capacity batteries for $120. Strange thing was they had...

Haven't posted in a while. Picked up a few bits off the matco truck. Everything bar the disconnect tool set was a special on the flyer. Both extension sets were but one and get the XL one free. Picked up the air hammer from Gregg's Distributors for $115. I really like it as you don't feel too...

Just a pointer, the 3/8 torque wrench only goes to 200 inch pounds which wouldn't be enough to do wheels. Go for the half inch. Its a great deal, breaker bar to break the lugs free and a torque wrench to tighten them! Sent from my SM-G900W8 using Tapatalk

Very nice! I'll pick that box up eventually! Sent from my SM-G900W8 using Tapatalk

That's the one