Recent content by Garage Customz

I have a room in my garage that I keep tools and paint and other stuff locked up and heated, so I didn't want the heat escaping. So what I did was cut the threshold straight down the sides of the jamb. Now when I have the heat on, the threshold stays in the doorway, and when I need to roll...

Take a piece of the DuraPanel and hold it to a piece of plywood, so that the profile of the panel can be traced onto the plywood. Now take that profile template and trace it onto the sheet rock you will be taking to the ceiling. Cut the profile out as you have it traced, and it should fit like...

These are made in The USA. http://www.genevagaragegear.com/storefront/shop/default.aspx

24x24 is not a small space, so have you thought of building a closet that you could put some wire shelves in and then heat with a small baseboard electric heater? I have a 10x10 "room" that I built inside of my garage to store all of our tools and items we don't want to freeze. We store...

As soon as we get time we are going to re-do our workshop/showroom area of the garage and do it with the vintage industrial look. On the longest wall, the plan is to do brick veneer (thin brick) to give it the warehouse/industrial look. On the other walls we are probably looking at cedar or...

What are your costs for the following: -Workers comp -Insurance -Labor per hour -Fixed overhead costs (IE: phone, rent etc) -Job related expenses (IE: material pick up, proposal time etc.) I mean....you do figure all this into your pricing don't you. Its called overhead.

Make sure, as already stated to spend a load of time on your prep. You might want to look into some sort of leveling system for the tile also, as a 48" tile can be tough to get perfectly even from front to back for a first timer. I have seen these used and they seem to be a great help. I am...

I had posted a few weeks ago about digging thru my Dad's old tools finally and finding some cool stuff. Well check out the Vise I found stashed away on one of my shelves that was his. It says The Chas. Park Co. Merident OT USA Nov 22 1910 Model # 202 Anybody know anything about these?

Thanks.

Finally got my stainless top put on my bench yesterday. Turned out great, now I can get on with the rest of the garage.

Geneva Cabinets. Made in Illinois. http://genevamfg.com/geneva/

I will be installing my top on Monday or Tuesday. My frame is the welded sguare tube with laminate cabinets setting in the frame. I installed 2 layers of 3/4" MDF as the sub top, and will put 16ga S/S over that. Really only need to lay a few lines of silicone over the MDF and then set the S/S...

I started a thread about the same thing, only mine situation was my dad had died and I was given all of his tools. One of the cool things is that there are several that I use almost every day either around the house or on the job. I think my old man would be pretty proud of that.

Made sliders!

That is scary. I have a 30x40 garage, completly insulated and finished out. Inside of that space I have a 12x12 section that is built out to be a seperate space. I heat the small space year round with the small electric radiator type heaters set on low, this will maintain a 55-60 temp range...