Recent content by gft

Follow Up: Just got project to the end. Yesterday I put the sump basin in after enlarging ground hole diameter, allowing me to use a 22-1/2° elbow, that aligned squarly to side of drum, using standard hole saw. Really detest digging but it happens.

Thanks everyone for your input. I'm going with jack stand's idea: Cut scrap piece of pipe to match side of drum, trace it, and cut with jigsaw.

Just realized that's wrong thinking. But slow might be the way to go

I have a buddy who is a fabricator/machinist. I'm thinking he could make one of the bits longer, and if i can keep it from wandering, it might work.

Thanks Andy, I'll look into that. Are you refering to: Carbide Tip Adjustable Circle Cutter

Hi everyone. I posted this on another forum but thought of the vast wisdom you guys possess. I'm needing to drill 3-1/4" hole into side of 24" diameter plastic drum off center (not square to side of drum). I've put a longer pilot bit on but think a little less than half of teeth will be all the...

have you tried panzitta's tech support?

try google: Panzitta Sales & Service