Recent content by Gigemags05

Ceiling fans aren't really a feasible option due to the ceiling height, wiring, and mounting options. I wish I would've thought about ceiling fans in the planning stages of this, but I don't think they are an option anymore.

I have an 18x35x9 shop. I have a dedicated circuit that has four outlets for fans. They are 8' high. I am also running an 18000 BTU mini split. My questions: How much CFM should each fan have for adequate circulation? How loud is it going to be in there with 4 fans going? I want good air...

When I left for work this morning, there was no cloudiness and quite a bit of the shine is back in the sealant. Hopefully it stays that way. I will have to touch up some spots with the stain and then I'm going to wait a week or so before resealing this time.

I put xylene down this evening and it seems to be helping. I'll check in the morning after it's all dried up. There are some spots where I'll have to restain because I pressure washed the sealant and stain off. Will I need to acid etch those spots again? Should I put another coat of sealant...

It's eagle supreme seal. http://www.eaglesealer.com/products/supreme-seal

I will find a link. It is solvent based

I stained my slab in my shop with eagle stain from homedepot. I realize it's probably not the top of the line product, but it was on clearance for $1/gallon so I figured what the heck. I followed all the instructions and steps. The stain went down goods and the color was what I wanted. I put...

17.7 seer

Pioneer 18,000 btu inverter+.

Just as an update: I ended up going with Pioneer. Amazon had a 3 yr replacement warranty for $68 and it was still a little less than the mr cool. Reviews are great for it, whereas I couldn't find reviews for the mr cool (non diy) set. Lastly, the pioneer will be here a week sooner. I'll try to...

The building is 18x35x9 I did the 12 gauge upgrade, added welded trusses, and had a vertical roof. They also added a wainscoting around the bottom that matches the trim and roof. There is a 10x8 roll up door on the front, a walk door on the front, and a 6x7 roll up on the right side along with...

One last bump for this... I need to order my unit tomorrow and am still going back and forth.

I've read a few reviews on eagle carports on this site. Quite frankly most of them were less than stellar. But after extensive research and taking all variables and factors under consideration I went ahead and placed my order for my new shop through them. My reasoning was as follows: 1.) they...

I went to a habitat for humanity re-store and got a large, double basin sink for $40. Not sure if they have those stores everywhere

I'm looking for a faucet for my utility sink that's going in my new shop. It'll be a sink mounted faucet. I'd like to have a tall neck, that has a threaded end so I can attach a water hose to it. Anyone have a good one that they like? I can't break the bank on it, but would like a good...