Recent content by gilbo

Nope none at all, because way easier and cheaper to order from Harry J. Epstein or Amazon JP.

KOKEN in the house!!!!!

I had that exact Craftsman setup for almost 25 years, now I upgraded to two 42" USG S3 roll cab and 56 roll cab " with top chest.

Yes, just last week Menards Irwin USA made tap and die

I just got my USA made Irwin tap & die set from Menards. I also got this set of press and pull sleeve. Made pressing in bushings a breeze for my suburban I also got a couple fluid extractors. The Four Uncles pneumatic/manual makes changing ATF a lot less messy. I just used this week to...

Thanks a bunch, just ordered one of each. Great starter sets

I have this set as well. Bought super cheap as well

VESSEL

This is the way!!!!

You can be the judge if these are worth anything

Con with gridfinity is that it takes up too much actual real estate in the drawer. Which defeats the whole purpose of maximization with organization for me atleast.

I printed 83 boards, so approx 332 hours. I printed 4 drawers, (3-42", 1-56"). It wasn't big deal, not like you have to sit there and baby sit the print. I would cue it up to print 2 boards on weekdays, after work. Then on weekends 3-4. I wasn't in a hurry, I figured I have never had Toolgrid...

Ask and you shall receive. 3D Printed Toolgrid

This is from a few years ago

Koken in the house again!!!!!!!