Recent content by glue4u

I have welded both sides all the way around and I have welded all the way around the side that is seen after it has a tire on it and just stich welded the inside. When I finish welding, I wire wheel the inside and fillet with a bead of silicone to make sure I won't have an air leak. The key is...

I've done this several times and the wheels have always turned out to be more accurate than the originals I started with. Not as difficult as everyone thinks. Leave yourself some additional material on your two halves and rough cut them with a plasma. Set a height gauge or surface gauge to...

Curious as to tracking/panhard bar for front. I didn't see it in any of your pics.

Curious if you could scan a drawing or even a cut paper template and convert it easily into a cut file? I make lots of poster paper templates now before I cut any steel by hand and I know the time savings with the CNC would be huge, but I have some learning to do. I've downloaded Draftsight to...

Looks like beneficial space. I'm curious about your garage doors. What size are they? With the narrow spacing separation between them, why did you not just use a wide single garage door?

I built a pole shed (about 18'x30) back in about 1995 and roofed it with this stuff. I sold the house to my brother and just noticed last week how bad that stuff looked. It has what appear to be splits or tears in it and it is a leaker. I'm guessing that the combination of heat and or UV...

There is a difference between HUCK BOLTS and HUCK SPIN BOLTS. HUCK SPIN is the newer stuff. The $800 is the mandrel piece that actually goes in the tool. If you have the tool to install these, which requires electric/hydralic power source, you would have a serious investment and obviously the...