Recent content by grizz_660

700 sq ft. 8' ceiling. Insulated walls, ceiling, and garage doors Sent from my iPhone using Tapatalk

I didnt purchase it. Its on Kijiji and I was curious to know if the crack could be repaired - reason being, HE said it could. I was always under the impression that they cannot be repaired. Sent from my iPhone using Tapatalk

Gotta love internet forums. Do I have to ask? No. I dont. Im not an expert and was asking if it could be done. As I stated in my original post; I was always under the impression that it could not be done. Should I apologize for not knowing something? Yes, carbon monoxide is no joke. Again...

Looking at a used Reznor UDAP200 heater for my garage. Guy says there is a crack in the heat exchange and says it can be welded. I was always under the impression that they cannot be welded. A new heat exchanger is $1600. A new heater is $1200. Guy is un sure if the heat exchanger is aluminum...

SQ D or Eaton Siemens if nothing else available.

Not sure if you have Philips down in the states, but I have had tremendous luck with Philips lighting products. HD sells Phillips up here. In buying LED lamps for the last 3 years, I have only ever had one issue with one particular light. It would randomly turn off by itself. Customer noticed it...

Depending on the inspector, I have seem them get picky about having lighting shared on a 20A cct. You would have to make sure your light switch is 20A rated as well as all the wiring between the lights. Make sure you do a load calculation and you do not have too many devices per circuit. When...

Make sure the switch ( for your porch light) has a neutral in it, not just a 2 wire. Sometimes, depending on the electrician, they will go to the light with their 120v, and go to the switch with a 2 wire. this 2 wire is just for switching, there is no neutral.

Octagon boxes use 8-32 device boxes ( such as 1104, 2104, 1110 ) use 6-32

Perfect. Thanks for all the help.

This is what I am concerned of as well, which is why I wanted to leave it open. Im not using it daily, maybe weekly. I dont mind letting it fill from 0. If I only needed it for something quick, i can start it up until I have what I need. I figure if I leave the drain open, then no moisture can...

+1. Yes you are ok to run a 3 wire and share the neutral.

So, is the general consensus that I do not need to drain the tank after each use? My thoughts are that if I leave the drain open when not using it, moisture will not be able to build up inside the tank. When I want to use it, I will close the valve and start it up. Why should I not extend the...

The electrical contractor should be able to do a load calculation based on bedrooms / sq ft / bathrooms / appliances / heating source. Having said that, if you are going so far as to upgrade the service, just go 200A and be done with it. 200A is more than most people need anyway, even in a big...

There should be a sticker or nameplate on the printer somewhere showing electrical information ( voltage, amperage, power consumption , etc ). See what it is. Some printers do require a seperate cct, others do not. If it is over 10amps, you should look into a seperate cct. It may have an effect...