Recent content by Hattrick4467

Also another question on the 93642. My reservoir has just a plug with a gasket. Should it have a vented plug?

The tip on the bottom of the relief valve is like this. This kit has a ball. Seems like mine should have a ball. Anyone know what size it should be? @Hiball I need help.

I am rebuilding my Lincoln 93642 jack and have a question on the relief valve. I thought i was careful when disassembling and do not believe there was a ball at the bottom of the relief valve. I bought a kit from hydraulic supply and the kit only contained two balls in it which will both be used...

Where is the best place to buy a quality rebuild kit for the 93642? And are there any extra parts I should replace during the rebuild that are not in the kit?

Where is the best place to buy a good quality rebuild kit? From @Hiball ? I messaged him but he did not respond. Maybe best to call them?

I believe this jack is older than 2004 as it is even an older Lincoln model based on a comparison i was watching on youtube. Does the model C or the serial identify the year or range of years in any way?

I have a Hein Werner 93642 Model C floor jack. I believe it is an older model based on some rebuild videos i have watched. Is there a way to identify the model year? There is what i believe to be a serial number tag and i had read that the month and year were part of the serial number. I have...

Thanks Hiball. The manual refers to a release. I saw in one photo of a j134 restore that there appeared to be a tab on the release rod. Mine does not have that. I just cannot figure out what allows or pulls the shorter rod up. The two rods are connected with basically a thick felt washer but...

I picked up a walker 4 ton jack that has issues. WhAt would you expect for $20. The question that I have is about the rod that allows you to lower the jack handle. I think the parts list calls it a plunger. The issue I have is that this plunger is broken off the end of the short rod. If I am...