Recent content by Hayden_yp

It does work, I might just leave it as is like you said and only clean up the shaft.

Hi all, This might not be the best place to post this thread but bear with me, I am new to the forum. I'm restoring a bench grinder and the rotor has this red finish over it, it's all patchy so I don't know if I should leave it as is or repaint it. I believe its Glyptal but I am not entirely...

Showing 2 amps on the metal badge

I'm currently restoring a GMF 6" Grinder. I plugged it in and it's not running therefore I'm assuming it's the start capacitor because the motor coils look fine and the switch works normally (I've tested with a multimeter). It looks like someone has replaced the start capacitor before and the...