Recent content by hdhogman

I have a 2006 Tiffin Openroad that the mirror pivots at the base mount are faze up and cannot adjust. I have tried to soak with WD-40 and PB blaster with no luck. It has 1 bolt through bottom that locks it in place via a taper. I did try to shock with rubber mallet, no luck. Any suggestions...

Possibly :dunno:

I have a question on removing rust from a sandblasted surface. I am in slow process of a tractor restoration, parts were blasted and were fine for a few months in my garage. This winter I turned heat on at one point and conditions made the surface gather excess moisture and then rust.Tractor is...

The flag pole I have is from http://www.uncommonflagpoles.com Made in MN. Quality unit with a decent selection of accessories.Check them out.

"Marginally Asian ****" or "Make Another Choice" :lol:

Do those footings include a frost wall to a certain depth ? I am from West Michigan and was told that I would be required a frost wall 42" deep to construct a stick built garage, sound un reasonable or not ?

Significant Other ?

I think the big tool box need is generated by the tool manufacturer. For example, the plastic boxes that a tool kit comes in, it is engineered too tall to fit in the drawer by approx. 1/2 inch, thus the necessity to put it in a drawer that is nearly twice as deep, there by wasting space. :headscrat

After reading/following this thread I made the trip to specifically see the dozer. I recommend any one that lives in the Midwest to go see it. Had a great conversation with Dozerbuilder. Thanks:thumbup:

Dozerbuilder, Now that it has paint, you may have to move some picture to the thread of awesome.

They look to be service tools for splicing/repairing chainsaw chain.

Probably posted before some time ago

I personally have an earlier version and would think that is a reasonable price. That statement "flimsy" is not warranted. I use this box daily, move all around our shop and it is FULL !

I have used these for many years. http://www.vimtools.com/Large/v515.jpg

I have an older KRSC46,looked at the 246 and thought about trading. After checking specs decided it would be a wash. I think square inch layout was very close. I'm not sure the extra $ for the 246 is worth it. I hope all shoppers are doing their homework. :headscrat